Using support bars or blocks with an additional frame that rests on the ceiling grid will work too. Make sure you can mount the light so it's flush with the face of the tile. T-grid mounting plates are available for canless LED downlight fixtures to help support the weight.
On each ceiling tile where you're adding a recessed light, trace the light's outline. Do this in the exact center of the tile, and double check that the opening is sized according to your light's installation instructions.
Cut the first hole out using a keyhole saw or utility knife. Dust off any loose particles and set the panel back into its opening. If you mistakenly cut a whole too large, don't worry, extended goof ring trims are available to mask any imperfections made in the ceiling while cutting.
Take out one panel next to the panel you just cut. Place the light up over the cut panel and attach it to the supports. Make sure it's positioned over the hole. If you're not familiar with how to wire your lights to power, it's best to hire an electrician. Most municipalities require a certified professional to connect the lights into your home's main electrical box and inspect the circuit.
This can be very dangerous to do if you're not trained for it. Install the light bulbs into the cans if necessary and snap the trim ring onto the housing. Turn on the lights, and voila! For more information, visit the recessed lighting page.
Subscribe to our newsletter and be the first to know about exclusive offers! Invest in Online Stores, Inc. The future of niche retail - Visit us at StartEngine. Search Keyword:. LED Canless Downlights. Follow these steps to add recessed lights to your drop ceiling: 1.
Read the manufacturer's instructions for the lights you purchased, but the basic rule of thumb when connecting wires is to match colors. Strip 2 inches of sheathing from each end of the cables, and one inch of insulation from the black and white wires inside the cable with wire strippers. Twist the bare end of the white wire from the cable to the bare end of the white wire from the light together with a pair of pliers.
Place a plastic connector cap on the wires, and twist it two or three times to tighten it. Repeat this with the black wires. The ground wire in the cable has no insulation, and the ground wire in the light can be bare or green. Wrap the ground wire around the ground screw on the light fixture if it contains one , and twist the ends of the two wires together. Slide the lighting can into the hole in the tile.
Pop the slots on the sides of the can out. These hold the can in place in the tile. Screw in the light bulbs and install the trim for the recessed lights.
Replace the ceiling tiles that you removed. Slide the cables inside the wall into the knockout holes on the old-work box. Slide the box into the wall and screw it into place. Strip the ends of the cables as you did with the light fixtures.
Bend the ends of the black and white wires into hooks with a pair of pliers. Cut a 3-inch-long piece of ground wire from the leftover cable.
Loosen the brass-colored terminal screws on the sides of the light switch. Hook the black wires onto the screws and tighten them. Connect the white wires to the silver terminal screws. Connect one end of the 3-inch ground wire to the ground screw on the bottom of the light switch.
Twist the other end to the ground wires inside the cables with a plastic connector cap. Place the wiring and light switch into the electrical box. Screw the light switch to the box with the mounting screws. Screw the plate cover into place. Hire an electrician to connect the lights into your home's main electrical box, and inspect the circuit if your local building codes require it.
Most municipalities require that only a certified professional connect wiring to the main box as it's extremely dangerous.
0コメント